Twinchie card, Tag Holder, Flag Garland – made by Toni Herron for Twitchit Craft Kits
Christmas Traditional Kit
PROJECT ONE –
Starting with a plain cardstock 6”x12” - Fold this in half to make a 6”x6” card base.
Distress and Ink around all edges of pieces to be used on this card.
For the first layer of squares, cut all 9 pieces to 1/8” under 2” = 1.7/8”x1.7/8” (use off cut pieces)
Second layer of squares, cut all 6 to 1/8” under first layer – 1.3/4”x1./34” (use off cut pieces)
Lay them onto your card to create a topper design. Move and rotate pieces until happy with how they are laid out. Stick down the first layer then add some foam tape / 3D dots / cardboard to make the second layer pop to give dimension. Finish off card with some tags and stickers from the sticker sheet in the kit.
PROJECT TWO –
Bottom layer RED – 14 Red/Green 1.1/2”x2”
Middle layer GREEN – 14 Red/Green 1.1/4”x1.3/4”
Top layer WHITE WITH STRIPE – 14 Twenty Five Days 1”x1.1/2”
Cut a small 1/2" tail in each flag piece. Do this on ALL layers.
Now stick all layers together making 14 full flag pieces.
Add each letter from the “MERRY CHRISTMAS” stickers on just a little bit lower from the top edge. This leaves room to poke some holes into each banner on the top sides and threading twine back and forth to create a hanging garland.
PROJECT THREE- Accordion Tag Holder
Festive Florals 6”x10”
Score long side at 2.1/2”, 5” & 7.1/2
Score short side at 4.1/2 – fold this up to make a pocket.
Add a brad
onto the far left and right sides to secure the bottom flap up.
Add some washi tape for decoration.
Fill with tags from Christmas Tags pattern paper and fussy cuts from the bonus mystery sheets.